Airspace

Can you fly a drone under a Class C shelf? How to read the numbers

Reviewed against the FAA sources below 4 min read

What Class C looks like on the chart

On a VFR sectional chart, Class C airspace surrounds a busy airport with a control tower and radar approach control. It is drawn as solid magenta lines, usually two rings around the airport:

  • The inner ring (the surface area) normally has a radius of 5 nautical miles. Inside it, Class C starts at the surface.
  • The outer ring (the shelf) normally runs from 5 to 10 nautical miles. Here Class C doesn’t reach the ground. It starts at a floor, usually 1,200 feet above the airport’s elevation.

Both normally reach up to 4,000 feet above the airport. Real Class C areas are often cut to fit the terrain or nearby airports, so always read the numbers on the chart in front of you, not the textbook shape.

What do the numbers mean? “43 over 15”

Each section of a Class C ring carries a label in magenta: ceiling over floor, in hundreds of feet above mean sea level (MSL).

LabelCeilingFloorWhere you see it
43 over SFC4,300 ft MSLthe surfaceinside the inner ring
43 over 154,300 ft MSL1,500 ft MSLbetween the inner and outer rings

So the rule to remember is short: the bottom number is the floor. If the floor reads SFC, Class C starts at the ground. If it reads a number, Class C starts that high above sea level, and there is open space under it.

How high is the floor above you?

The chart gives the floor above sea level. Your drone’s limit is measured above the ground. To compare them, subtract the ground elevation at your spot from the floor:

Floor above you = floor (MSL) − ground elevation (MSL)

Take a spot 8 statute miles from the airport (about 7 nautical miles), under a shelf labeled 43 over 15, with the ground at 340 feet MSL:

  • the floor is 1,500 feet MSL;
  • 1,500 − 340 = 1,160 feet above you;
  • your Part 107 limit is 400 feet above the ground (§107.51(b)).

1,160 is well above 400, so your whole flight stays in the airspace under the shelf. That’s not Class C, and Part 107 doesn’t require ATC authorization for it (§107.41 lists Class B, C and D and Class E surface areas).

Side view of Class C airspace. Inside 5 nautical miles it reaches the ground. From 5 to 10 nautical miles it is a shelf from 1,500 to 4,300 feet above sea level. At 7 nautical miles the ground is 340 feet, so the shelf floor is 1,160 feet above it, well above a drone at 400 feet. Inner ring surface to 4,300 ft MSL label 43 over SFC Outer ring (the shelf) 1,500 to 4,300 ft MSL · label 43 over 15 Your limit · 400 ft Gap · 1,160 ft Airport 5 NM 7 NM · you 10 NM ground 340 ft MSL
Side view. Heights are to scale with each other; distances are squeezed, so the picture is about 7 times taller than life.

You can find the ground elevation on the sectional itself: the terrain colors and contour lines, the spot elevations, and the elevation in each airport’s data block. A mapping app’s elevation readout works too.

Try it

This is the same question, the way the Airspace Class course will teach it. Pick an answer.

Sectional chart excerpt around Millbrook Regional (fictional) A towered airport, Millbrook Regional, field elevation 312 feet, inside two concentric solid magenta rings. The inner ring is labeled 43 over SFC, the outer ring 43 over 15. A YOU marker sits between the rings, about 7 nautical miles from the airport, at the town of Cedar Bend, with a spot elevation of 340 feet. CEDAR BEND 1049 (709) 829 (489) MILLBROOK RGNL 312 L 72 43 SFC 43 15 43 15 340 YOU 0 5 nautical miles N
  • Solid magenta: Class C
  • Blue: airport with a control tower
  • Ground elevation, ft above sea level
  • Tower: top above sea level (height above ground)
Chart excerpt, fictional airport, drawn in the style of an FAA sectional. Rings, YOU and the scale are in true proportion: 5, 10 and 7 nautical miles.

Try one · Part 107 · Airspace

Can you fly here?

Your client’s roof is in Cedar Bend. There’s a big airport 8 miles away.

Inside the inner ring, ask first

Under 43 over SFC, Class C starts at the ground, so any flight there is in Class C. Under §107.41 you need prior authorization from ATC before you fly. For most places you can get it in minutes through LAANC, using one of the apps the FAA lists, or you can apply through FAA DroneZone for places and altitudes LAANC can’t approve. Either way the approval comes with a maximum altitude for that spot.

Before you fly under a shelf, check these too

Class C is only one layer. For the same spot, also check:

  1. Other airspace that reaches the ground. A dashed magenta line (a Class E surface area), a blue line (Class B or D) or a nearby Class D can sit under or next to a Class C shelf.
  2. Temporary flight restrictions and NOTAMs. A TFR can close a spot that the chart says is open.
  3. High ground. On rising terrain the same floor gets closer to you. Do the subtraction for the exact spot, not for the town.
  4. Your own limits. 400 feet above the ground, visual line of sight and the weather minimums all still apply.

The one line to keep

On a Class C label, the bottom number is the floor, in hundreds of feet above sea level. Subtract the ground. If that floor is more than 400 feet above you, you’re flying under Class C, not in it.

Questions

Are the Class C numbers above ground level or above sea level?

Above mean sea level (MSL), in hundreds of feet. 15 means 1,500 feet MSL. To know how high the floor is above you, subtract the ground elevation where you stand.

What airspace is under a Class C shelf?

Whatever the chart shows below it, usually Class E above 700 or 1,200 feet and Class G near the ground. Part 107 needs no ATC authorization in Class G, or in Class E unless it is a surface area, drawn as a dashed magenta line.

Do I need LAANC to fly under the outer ring?

Not for Class C, as long as you stay below its floor. You need authorization only if your flight enters the shelf, or if the spot sits in other controlled airspace that reaches the ground, such as a Class E surface area.

What if the ground is high and the floor is less than 400 feet above me?

Then the floor is your ceiling. Stay below it, or get ATC authorization before you climb into the shelf. Always subtract the ground: a floor of 1,500 feet MSL over ground at 1,300 feet is only 200 feet above you.

Can I go above 400 feet near a tall building under the shelf?

Part 107 lets you fly higher within 400 feet of a structure, up to 400 feet above its top, as §107.51(b) states. But if that takes you into the shelf, you are in Class C and need ATC authorization first.

Course opens soon

Learn all of Part 107 the easy way.

Short visual lessons and timed practice tests. Leave your email and we’ll tell you when the course opens.

Sources

  1. 14 CFR §107.41, Operation in certain airspace (eCFR)
  2. 14 CFR §107.51, Operating limitations for small unmanned aircraft (eCFR)
  3. FAA Aeronautical Information Manual, chapter 3, section 2: Controlled Airspace (3-2-4, Class C)
  4. FAA Aeronautical Chart Users’ Guide
  5. FAA: Part 107 airspace authorizations (LAANC and DroneZone)

Airspace Class is an independent course, not affiliated with the FAA. Rules change: check the current regulations and charts before you fly. Found an error? Email [email protected].